Installation Instructions - NGK Power Cables

Wire Set Installation Instructions

STEP 1: Remove the old spark plug wires, one at a time, replacing them with the new NGK Wires. Follow the numbers clearly shown on each wire.  Each NGK wire has an identifying cylinder number affixed to it.  Match wire to appropriate cylinder by using this number.

STEP 2: Use the existing clamps wire looms and retainers and follow the original wire paths.

STEP 3: Press the boot end of the wire onto the spark plug until it snaps on securely. Insert the other end firmly into the proper terminal on the distributor cap or coil pack.

STEP 4: Install the coil wire where applicable: The blue cap end to the distributor, the black cap end to the coil.

STEP 5: When removing the wires, pull only on the boot. Do not pull the wires.