Wire Sets Installation

STEP 1:
Remove the old spark plug wires, one at a time, replacing them with the new NGK wires. Follow the numbers clearly shown on each wire.

STEP 2:
Use the existing clamps and follow the original wire paths.

STEP 3:
Press the boot end of the wire onto the spark plug until it snaps on securely. Insert the other end firmly into the proper terminal on the distributor cap.

STEP 4:
Install the coil wire: the blue cap end to the distributor, the black cap end to the coil.

STEP 5:
When removing the wires, pull only on the boot. Do not pull the wires.